LL 1660 /18 ma as PP.

Get technical support here for your Lundahl Tube Power Supply Chokes, Filament Chokes, Plate Chokes, Interstage transformer, Grid Chokes, Signal Input transformers, Moving Coil transformers, Microphone transformers, Digital Audio transformers, SE or PP Tube output transformers, air gapped mains transformers, or the Lundahl problem solver series.

LL 1660 /18 ma as PP.

Postby johan » Tue Feb 16, 2016 12:35 am

Hello
I have a LL 1660 /18 ma interstage transformers . My first idee was to use it as SE to PP to drive 6b4g tubes .(P.P ) (russian ecc99 (6N6P) as driver tube )
I could buy recently some LL 1540 high input, high impedance transformers and now I want to use them for phase splitting instead of the LL1660 . Is this a good idee or should I stick to the first configuration ?
When I will use the LL1540 for phase splitting the LL1660 has to work PP to PP instead of SE to PP . How does the LL1660 /18 ma perform in this configuration ( P.P to P.P ) and which tube should I use to drive the transformer P.P. to P.P .
Thanks and regards
Johan .
johan
 
Posts: 1
Joined: Tue Feb 16, 2016 12:18 am

Re: LL 1660 /18 ma as PP.

Postby Jac19 » Sun Feb 28, 2016 10:50 pm

Sure you can use the LL1660-18mA also as Push Pull. Just take the wiring scheme from the PP. The only thing is, inductance is lower as with a real PP transformer. Though ECC99 is nicely low impedance. In any case LL1660-18mA will work, but the low frequence 3dB point I can not say. You need to calculate that . As you already have the LL1660-18mA available, you can just try it out. Then when you it doesn't go low enough, that means you need to use a PP transformer instead. In any case LL1660-18mA will work, and you are probably ok with it.
Jac19
 
Posts: 21
Joined: Sun Dec 29, 2013 10:54 pm


Return to LUNDAHL FORUM

Who is online

Users browsing this forum: No registered users and 2 guests

cron