Primary connections of transformer

Get technical support here for your Lundahl Tube Power Supply Chokes, Filament Chokes, Plate Chokes, Interstage transformer, Grid Chokes, Signal Input transformers, Moving Coil transformers, Microphone transformers, Digital Audio transformers, SE or PP Tube output transformers, air gapped mains transformers, or the Lundahl problem solver series.

Primary connections of transformer

Postby xmk » Thu Jan 09, 2014 1:08 am

Hi, I want to use the LL1679 as SE OPT and also get an UL tap.(30-35%)
To achieve this I need to connect the primary coils in a different way than the one suggested in the datasheet.
Is there a particular combination I need to follow (i.e. inner windings then outer or inner-outer-inner etc.)
I have attached my guess of how I should connect them.
Could somebody confirm or correct me
LL1679_SE_UL.jpg (169.32 KiB) Viewed 3094 times
Posts: 1
Joined: Thu Jan 09, 2014 12:57 am

Re: Primary connections of transformer

Postby Andrio » Tue Dec 23, 2014 1:27 pm

Btw, this is not a choke input question setup and minimum current to make it working, but rather choke only charakteristics and usable current range. At one end we have the max core tesla limitation for a particular core gap to handle DC current, at the other end we have a minimum current to enable the inductance generation
Posts: 1
Joined: Tue Dec 23, 2014 1:18 pm


Who is online

Users browsing this forum: No registered users and 1 guest