Anko Model 360

FORUM about all Other tube testers, not listed below

Anko Model 360

Postby ibis12 » Thu Sep 20, 2012 1:30 am

Greetings,

I am just getting into tube testing and tube amplifiers. I bought an Anko Model 360 tube tester on Ebay, and it appears to be broken. When you set the A,B,and C switches and insert a tube (or don't insert a tube) the unit shows 80 on Gas - 80 on Shorts - and pegs below zero on Test. Do I have a filament tester here, or a real tube tester? Not sure where to start on the repair. Any ideas would be greatly appreciated.

Image
Image
Image
Image
ibis12
 
Posts: 2
Joined: Thu Sep 20, 2012 1:21 am

Re: Anko Model 360

Postby Admin19 » Sat Sep 22, 2012 10:11 pm

Hi,

if there are some operating instructions inside the lid, perhaps you can post a good picture of it? Looks like a nice tester to me, because there are a lot of components inside, and optical condition is very nice. On Ebay tester are normally broken, it's kind of normal there. Or, you are just operating it wrong.

Jac
User avatar
Admin19
Site Admin
 
Posts: 65
Joined: Sun Dec 11, 2011 1:55 pm

Re: Anko Model 360

Postby ibis12 » Sun Sep 23, 2012 11:48 pm

No real instructions inside the lid. just settings for the various tubes. It looks like a power supply and switches. Could it be the capacitor? Thanks
ibis12
 
Posts: 2
Joined: Thu Sep 20, 2012 1:21 am


Return to OTHER Tube testers

Who is online

Users browsing this forum: No registered users and 1 guest