temp on power tube plates?

About the Emission Labs tubes and how to use them.

temp on power tube plates?

Postby istvan01 » Sat Feb 03, 2018 4:44 pm

I have all DHT monoblocks with SE-PX25M/PP-2A3M/PP-520B Plitron OPT on end. The tubes have been working since 2005 great.
I have a radiation thermometer and this can measure through the glass temperature of anode plates. The plates have highest temp on top.
I measured 188-195C on 520B /115mA-470V/
102-107C on 2A3M /45mA-225V/
70-72C on PX25M /24mA-240V/
My question is, what would be minimum and maximum operating temp of these tube plates?
Does exist optimal temperature on plates, according to life time also?
Attachments
DSCF6950r.jpg
DSCF6950r.jpg (216.15 KiB) Viewed 1563 times
istvan01
 
Posts: 2
Joined: Sat Feb 03, 2018 4:03 pm

Re: temp on power tube plates?

Postby MaciekP » Wed Feb 07, 2018 3:18 pm

Really can see through glass?

https://www.thermoworks.com/infrared_th ... f_infrared

"Do not "see through" glass, liquids or other transparent surfaces - even though visible light (like a laser) passes through them (i.e. if you point an IR gun at a window, you'll be measuring the temperature of the window pane, not the outside temp)"

Talking about bulb temperature, for some tubes I saw the max of 250C.
For many transmitting tubes it is allowed to have red anodes and it is fine.
I'm sure JAC can share his experience on that...
MaciekP
 
Posts: 17
Joined: Wed Dec 04, 2013 9:14 am

Re: temp on power tube plates?

Postby istvan01 » Mon Feb 12, 2018 12:58 pm

Attachments
Flame_detection_spectrum.JPG
Flame_detection_spectrum.JPG (22.27 KiB) Viewed 1497 times
O9HxM.jpg
O9HxM.jpg (48.43 KiB) Viewed 1497 times
istvan01
 
Posts: 2
Joined: Sat Feb 03, 2018 4:03 pm


Return to EML FORUM

Who is online

Users browsing this forum: No registered users and 1 guest

cron